Hello. My touch controller frame has a problem. When I lift my finger from a slider,it moves a little more than expected.
It is difficult to position it precisely. Is it possible to replace the slider with buttons ( +/-) in order to increase or decrease
the values of this one?
Patrick
Hello, you can replace slider with buttons, al what you need is setup the sliders as a encoder on your software in order send increment or decrement MIDI.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5
@savethehuman5
Ok thank , i will try
Hi , i can't do this on Ableton live , or i can't understand what you said ?
You have multiple choices,
One is do a pile of buttons, and assign incremental MIDI CC value to all buttons, of course what is controlled will jump to that values.
The second way is map a slider in Ableton as a encoder, what basically is a midi mode accept incremental values.
Finally you need consider change your IR touch by a capacitive touch, what solve all problems.
Asus Vt229h is a very good affordable solution.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5
@savethehuman5
Hello
My IR frame no longer works due to the bad USB connection.
So I bought the DELL HP2418HT monitor and it works very well with Chameleon.
I have no more problems with the sliders. Their movements are very precise.
So I am currently making a new template to improvise under ableton on 14 tracks.
I hope to show you pictures quickly.
See you soon .
Ok. As you can see capacitive screen is a lot better and more accurate than IR frame.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5