Notifications
Clear all
Chameleon Troubleshooting, tips and tricks.
6
Posts
2
Users
0
Reactions
1,573
Views
Topic starter
11/02/2020 9:20 am
Hello,
First I thank you for making Panda, it was what Windows was lacking to make real use of touch screen controllers !
But I have a problem : if my laptop goes to sleep while Panda is active, my external mouse doesn't work anymore when I open it again. The tarckpad continues to work, but any USB or BT mouse even if I quit Pande. The only way to retreive my mouse is to restart the computer.
I have tried to simply close the session after I exit Panda but I get a blue screen !
I have tested on two computers with the same effect.
If I quit Panda before the computers go to sleep there is no problem, so I must just don't forget to exit it each time...
Nevertheless it would be nice to avoid it !
11/02/2020 5:55 pm
That is a limitation at kernel level of what software do, and can cause this problem.
I can take a look on that for see if there is some workaround.
I back soon with some info.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5
11/02/2020 5:56 pm
ASAP I create a section in the forum, just for PANDA, in order not mix thread in incorrect sections.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5
Topic starter
12/02/2020 2:46 pm
Thanks for looking, and yes, I didn't know where to post...
Topic starter
20/08/2020 3:11 am
Hi, did you have some time to look at this issue ?
I had to uninstall Panda from this computer in order to make the mouse working normally...
22/08/2020 7:48 am
Hi, no solution yet, continue trying but slow, in a middle a new big project I launch soon.
About: https://savethehuman5.com/about/
Youtube: https://www.youtube.com/SaveTheHuman5
Facebook: https://www.facebook.com/SaveTheHuman5